Tulsa Gas Technologies 2 hose CNG dispenser Model TGT-T7203-6CNG50,

Description

Tulsa 2 Hose dispenser Display is front and rear. Government maintained features 3/8th tubing.
1 3600 psi hose
1 3000 psi hose
With all keys.
Please view manufacturers description below.
I own a Tulsa at my Public station and I like it.
We can load on your common carrier.
6
Sequencing Valves
2
Pressure Gauges
2
Snap-tite In-Line Break-aways
2
Manual Shutoff Valves
1
Powder Coated Cold Roll Carbon Steel Body (Stainless Steel Optional)
2
Micro Motion CNG50 Mass Flow Meters (rated at 5000 Psi(345 bar), 170 lbs./min (77kg/min.), 3000 scfm) Flow Rates through the dispenser depends on vehicle capacity to receive gas and nozzle attached to dispenser hose. A ½" hose and a nozzle upgrade is required for flow rates above 1500scfm(42.47m3/Min).
2
ASME Relief Valves
This dispenser is a three-line dispenser that independently meters the gas and gives you a display on both sides of the dispenser. Flow Rate as high as 3000cfm have been seen with this dispenser in certain configurations. The New Micro Motion ® CNG50 sensor is used in this dispenser to achieve the flow rate. The dispenser has 2, 4-20mA output that can send flow or temperature to a remote controller. The dispenser has a dry contact and a 120VAC hook switch for an "in use" signal and will send pulses to a card reader or a console. The Micro Motion ® transmitters are located within the dispenser body and are factory set up and calibrated before shipment. TGT assembles an AGA 1-93 approved Parker Parflex CNG fill hose on all its dispensers. The Breakaway is the Snap-tite In-Line type with a unique vent Breakaway attached to the fill hose Breakaway. All TGT CNG Dispensers have an ASME pressure relief valve inside the dispenser cabinet with a vent stack up through the dispenser body. The cabinet is constructed of 11-gauge cold roll steel with a powder-coated finish; stainless steel material is optional. The high body style gives you the look of contemporary gasoline dispenser.  This dispenser will temperature compensate the fill pressure of the gas and do electronic sequencing of the gas from the storage to the dispenser using the Acufill® algorithm. All of the sequencing valves are  mounted internal in the dispenser.